Steps & Photos
Step 2: Measure out the table and find the length and width to figure out how much you want to cut out. For me the table was 22"x 22" so I cut into the table about 4"to make the center hollow leaving a platform for the LED's and wires to be set.
Step 3 : You want to make sure that the plexiglas has a place to be set over the LED's the inside of my table was a honeycomb so I ripped that out and set the glass on the top of the table.
Step 4: Now that you have the base cleared, drill a hole in any corner you feel and this hole will serve as the power cords exit to be plugged into an outlet.
Step 5: Setting up the LED strips. So everyone is different for placing the LED`s where they want, for me I wanted simple so I put the strips on the outer sides of the square cutout.
Step 7: Making sure the wireless remote can receive signal to the leds. Make sure you have it out of the table either under the table out of sight or somewhere where the remote can turn on the LED's
Step 7: Plug in your final product and use the table how you see fit.